TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 4 Copyright 2013 All Rights Reserved.
 GAPDETECT
Description
This command feeds the paper through the gap sensor in an effort to determine the paper and gap
sizes, respectively. This command references the user’s approximate measurements. If the
measurements conflict with the actual size, the GAPDETECT command will not work properly. This
calibration method can be applied to the labels with pre-printed logos or texts.
Syntax
GAPDETECT [x,y]
Parameter
Description
X
Paper length (in dots)
Y
Gap length (in dots)
Note:
If the x, y parameters are ignored then the printer will calibrate and determine the paper length
and gap size automatically.
See Also
GAP, SIZE, BLINEDETECT, AUTODETECT

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)