Other settings and functions 113
Beep on auto-reconnect
You can reconnect a held call both via the CTI application and via the phone. A
beep sounds when you toggle between an active call and a held call when the
function is active.
z You can also configure this setting via the WEB interface page 143.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
ñ
The CTI option was programmed by your administrator.
User
Configuration
Incoming calls?
CTI calls? f
AutoReconnect beep = No f
Yes l
Save & exit l
To Next Page
Loading...
