Making calls 45
Retrieving the second call
€ Switch to the held consultation or second call.
Choose the option shown.. You are connected with the other party. The first
called was put on "Hold" again.
Connecting parties
You can connect the first party with the party you consulted, clearing down your
connection to both parties in the process.
Prerequisite: You are conducting a consultation call page 42 and call joining
is allowed page 116.
Select and confirm the option shown.
The active and held calls are joined. You are disconnected from the call.
or Connecting by hanging up
] or : Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Placing a call on hold
You can use this function to place an ongoing call on Hold, for instance to pre-
vent the other party overhearing a conversation with a colleague in the same
room.
Prerequisite: You are conducting a call.
Select and confirm the option shown in the connection's context menu.
Retrieving a held call
Select and confirm the option shown in the connection's context menu.
Using line keys
On a multi-line telephone, you can also use the line keys to place ongoing calls
on Hold.
Press the corresponding line key. The line notification starts flickering. The call
is now on hold.
Reconnect? f
Complete Xfer? f
Hold ? f
If you do not retrieve the held call after a defined time interval, a reminder
beep sounds three times and a prompt to retrieve the call or disconnect
appears on the display. The settings for this can be found on page 114
and page 114.
Reconnect ? l
ñ
The line key function has to be configured by your administrator.
Line 1
_
To Next Page
Loading...
