Unify OpenScape CP200 - Programming a Key; Initiating Programming

Programmable keys 59
Programming a key
z You can also program the keys via the WEB interface  page 143.
Initiating programming
Directly via the function key
Hold down one of the three keys to which a function is to be assigned until the
programming prompt is displayed.
Confirm to begin programming.
or Via the user menu
You can also program keys via the user menu.
@ Press the key shown.
Confirm the option shown.
if nec. j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown. You are prompted to press the key you
wish to program.
Press one of the three keys you want to program with a function.
ñ
Must be activated by the administrator.
_
If the prompt is not displayed, you can only launch key programming via
the user menu (consult your administrator about the current setting).
OK
User
Phone
Program keys
_