Unify OpenScape CP200 - User Settings

27 Getting to know the OpenScape Desk Phone CP200/CP205
User settings
In the User menu (see  page 151), settings options are provided that allow you to adapt the tele-
phone to your individual requirements.
Select a menu using the Navigationstasten:
• "Date and time"  page 101
• "Audio"  page 90
• "Configuration" e.g.  page 84 or  page 117
• "Phone"  page 31
• "Locality"  page 95
• "Security"  page 85 or  page 88
• "Network information"  page 102
• "Diagnostic information"  page 136
• "Reset"  page 103
If you are in one of these menus or submenus, depending on the situation, you have the following
options to leave the menus:
• Save & exit (If you have made a setting and want to keep it)
• Exit (discard changes) (If you have made a setting that you do not want to use after all or if you
do not want to set any of the options)
• Back (If you want to leave the main menu or submenu)
• Press and hold the € key to access the option to leave the current menu level.
• You exit the menu by pressing the @ key and return to idle mode  page 21.
Interrupting editing in the menu
You can interrupt editing in the menu, for example to call someone or to answer a call. Pressing
the @ key takes you back to the point in the menu from which you exited.
This is only possible for a limited period, however, which is defined by the administrator using the
inactivity timeout setting. If the configured time expires, you need to re-enter your password when
opening the menu and manually go to the required point in the menu.
Interrupting editing:
• By pressing the @ key, you interrupt editing, leave the menu and return to idle
mode page 21.
• If you receive a call during editing and answer it, you automatically change to the call view (see
also  page 24).
To go back to editing mode in the menu, press the @ key again.