Unify OpenScape CP200 - Requesting Callback; Using Autodial Delay

Making calls 39
Requesting callback
You can request a callback if the subscriber called is busy or if nobody answers.
You receive a callback when the other party's line becomes free.
Prerequisite: The subscriber is busy or nobody answers.
Select and confirm the option shown.
Deleting callback requests
You can delete scheduled callback requests if you no longer need to return a
call, for example, at the end of the working day.
Prerequisite: At least one callback was requested. The phone is idle.
Select and confirm the option shown.
All callback requests are deleted.
Using autodial delay
A number is automatically dialed after a set delay starting from the entry of the
number's last digit. The autodial delay can be used:
• when dialing in idle mode
• during a consultation
• when transferring an answered call.
The delay can be reduced by performing one of the following activities:
Z • Press the key shown. This works at any situation.
^ • Lifting the handset. This only works if the phone number was entered when the
phone was idle or if it was entered for a consultation call when the handset was
off hook.
This option is only available if both you and your administrator have acti-
vated the function ( page 123).
This function is available with restrictions on an OpenScape 4000, see
 page 162.
Callback? m
Disconnect? f
If an emergency number is preset by your administrator, the autodial delay
for this phone number is reduced to one second.