78 Making calls in the team
Press the line key with notification. A conference is established. You are con-
nected to the parties on the secondary line. The key continues to illuminate and
the conference is shown on the display.
You can now:
• Put the secondary line on hold
• Leave the conference on the secondary line
• Make a consultation call
• Accept a second call
• Alternate between a new call party and a conference on the secondary line.
• Include a call party from a consultation or a second call in the conference.
Settings for MultiLine (keyset)
The details for each keyset line contain supplementary information for the user.
The following uneditable fields are displayed:
• Address
– Displays the phone number for the line
• Ringer on/off
– Displays whether this line's ringer is active
• Selection sequence
– Displays the priority of each line seizure when the handset is lifted or the
loudspeaker key for this line is pressed
Setting the time for a delayed ringer
Specify the length of time before a held call should be signaled on a line.
z You can also configure this setting via the WEB interface page 143.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the required line (for example line 1).
Select and confirm the option shown.
j Enter and confirm a delay value.
Select and confirm the option shown.
Line 1
_
If there is already a conference on the secondary line you are connected
to this conference. The conference is shown on the display.
User
Configuration
Keyset
Lines
Line 1 f
Ring delay f
Save & exit l
To Next Page
Loading...
