128 Other settings and functions
Displaying call log data from RingCentral API
By enabling the RingCentral synchronization option as described on page 25,
you can display call log records derived from the RingCentral API.
Prerequisite: Your administrator has configured the option to synchronize call
log data with RingCentral API.
Press the Konversationen key
For instance, select and confirm the list of dialed numbers.
Call recording
A central voice recorder is installed in the network for recording calls to which
your telephone connects in order to record the current voice traffic. The recorder
records the entire voice flow of two or more participants.
You should configure a recording button in order to simplify handling of manual
call recording page 59. It is assumed in the description below that a corre-
sponding key has been configured.
Recording modes
The administrator can configure the following operating modes for call record-
ing:
• Manual
• AutoStart
• All Calls
• Disabled
The following settings are possible to audibly signal the recording:
• Repeated
• Single Shot
•Off
Check with your administrator as to which settings were made for your phone.
Mode: ALL CALLS
The telephone starts and stops the recorder automatically in order to ensure that
all calls are being recorded.
Þ_
Dialled (x) l
On entering the call log list, your device will refresh the data from the Ring-
Central API and perform synchronization. Your device will update the call
log on each startup of your phone, when a call has finished or when your
administrator enables the sync call log feature..
To Next Page
Loading...
