Remote configuration for cloud service providers 13
Remote configuration for cloud
service providers
From factory defaults to operational
telephone
This section describes the remote configuration process, from the initial factory
defaults to the operational telephone. If your telephone is already operational,
please continue reading from Section "Getting to know the
OpenScape Desk Phone CP200/CP205 ( page 15)".
You can start up your new OpenScape Desk Phone CP200/CP205 yourself us-
ing a remote maintenance function. The prerequisites for this are:
• The administrator has provided you with a PIN for the initial start-up
• You have a LAN connection with access to the Internet
• You have a new OpenScape Desk Phone CP200/CP205 that you want to start
up using the remote maintenance function
Starting up the telephone
Connect the telephone to the LAN. If the power is not supplied by the LAN cable,
connect a power supply if appropriate (the power supply is not needed with
PoE). The telephone should now boot.
The telephone recognizes based on the stated conditions that a remote config-
uration is to be performed and starts this process.
Entering the Deployment PIN
The first time you start up the telephone, it will automatically check the remote
configuration requirements. If the requirements are fulfilled,
you will be prompted to enter the Deployment PIN (cloud PIN).
j Enter the PIN you received from your Fachpersonal. Only numeric characters
are accepted.
Confirm with the key shown.
©
Enter PIN...
Q
©
123456789
Q
Z
To Next Page
Loading...
Need help?
General
