Unify OpenScape CP200 - Page 138

138 Other settings and functions
64 LLDP-MED Operation Sent: Wed Oct 13 11:24:31 2021
Chassis ID TLV Data
.Subtype = Network address
.IANA_TYPE = IPv4 Address
.ID = 10.12.138.14
Port ID TLV Data
.Subtype = MAC address
.ID = 00:1A:E8:75:E0:54
TTL TLV data
.seconds = 120
System Caps TLV Data
.Supported = Bridge, Telephone,
.Enabled = Telephone,
MAC_Phy config TLV data
.Auto-set supported = Yes
.Auto-set enabled = Yes
.PMD = 0x6c00
.PMD1 = 10BASE-T half duplex
mode
.PMD2 = 10BASE-T full duplex
mode
.PMD3 = 100BASE-TX half du-
plex mode
.PMD4 = 100BASE-TX full du-
plex mode
.MAU = 100BaseTXFD : 0x10
LLDP-MED Caps TLV Data
.Caps - LLDP-MED = Yes
.Caps - Network Policy = Yes
.Caps - Location ID = No
.Caps - Extended Power Mdi PD
= Yes
.Caps - Extended Power Mdi Pse
= No
.Caps - Inventory = No
.Type = Endpoint Class III
Network policy (Voice) TLV data
.Policy unknown = Yes
.Tagged = No
.VLAN ID = 0
.Layer 2 priority = 5
.DSCP = 46
Network policy (Voice Signalling)
TLV data
Diagnostic.information