2AV/X
1-6-23
1-6
8. Loop the inner ends of the scanner wires around the grooves in the pulleys at the right of the scanner unit,
winding from below to above. ......................................................................................................................... 1
9. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from above to
below. .............................................................................................................................................................. 2
10. Hook the round terminals onto the catches inside the scanner unit. .............................................................. 3
Figure 1-6-33
11. Loop the outer ends of the scanner wires around the grooves in the scanner wire pulleys at the left of the
scanner unit, winding from below to above. .................................................................................................... 4
12. Loop the scanner wires around the outer grooves in the pulleys on the mirror 2 frame, winding from below to
above. ............................................................................................................................................................. 5
13 Wind the scanner wires around the grooves in the scanner wire guides at the left of the scanner unit. ......... 6
14. Hook the round terminals onto the scanner tension springs. .......................................................................... 7
Figure 1-6-34
15. Remove the scanner wire stoppers and frame securing tools.
16. Gather the scanner wires toward the locating balls.
17. Move the mirror 2 frame from side to side to correctly locate the wires in position.
18. Refit all the removed parts.
To Next Page
Loading...