System Menu
ADVANCED OPERATION GUIDE 6-21
6
Function Defaults
Defaults are the values automatically set after the warm-up is completed
or the Reset key is pressed.
Set the defaults for available settings such as copying and sending. Setting
the frequently-used values as defaults makes subsequent jobs easier.
Original Orientation
Set the original orientation defaults. The available default settings are
shown below.
Refer to page 1-10 for Original Orientation.
Use the procedure below to select the default orientation when originals
are placed on the platen.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Function Defaults and then [Change]
of Original Orientation.
3
Select [Top Edge
Top] or [Top Edge
Left] for the default.
4
Press [OK].
Continuous Scan
Set the continuous scan defaults. The available default settings are shown
below.
Item Description
Top Edge Top Select the original's top edge at the top.
Top Edge Left Select the original's top edge at the left.
Common Sett ings - Original Orient ati on
Select the default original orientation.
Top Edge T op T op Edge Lef t
Cancel OK
Status 10/10/2007 10:10
Item Description
Off Continuous scan not performed
On Continuous scan performed
To Next Page
Loading...
Need help?
General
