Security
ADVANCED OPERATION GUIDE 8-9
8
Warning Message
If the encryption
code information of
the machine has
been lost for some
reason, the screen
shown here appears
when the power is
turned on.
Follow the steps
below.
1
Press [Encryption Code], and enter the encryption code that was entered
during the installation of the Security Kit.
CAUTION: Even though entering a different encryption code can also
enable continuation of a job, this will erase all the data stored in the hard
disk. Exercise extreme caution when entering an encryption code.
The encryption code is not the same as the security password.
2
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
Enter the encryption code.
OK
Encryption
Code
To Next Page
Loading...
