System Menu
6-36 ADVANCED OPERATION GUIDE
NOTE: This setting is not displayed when the optional Security Kit is
installed or the Repeat Copy job is set to 0.
Refer to page 1-54 for Repeat Copy.
Use the procedure below to set the default Repeat Copy setting.
1
Press the System Menu key.
2
Press [Common Settings] and [Next] of Function Defaults. Press [T] twice
and [Change] of Repeat Copy.
3
Select the default for
[Off] or [On].
4
Press [OK].
Orientation Confirmation
Select whether to display a screen for selecting the orientation of the
originals to be placed on the platen when using the following functions.
(For more information, refer to page 1-10 for Original Orientation.)
•Duplex
• Margin/Centering originals
• Border erase
• Combine mode
• Memo mode
• Page numbering
•Booklets
• Stapling (optional feature)
* If [On] is selected as the Orientation Confirmation setting in the
System Menu, the selection screen for original orientation appears
when you select any of the above functions.
Common Settings - Repeat Copy
Cancel OK
Status 10/10/2007 10:10
Select the default repeat copy settings .
OnOff
To Next Page
Loading...
