Utax CD 1325

Sending Functions
2-12 ADVANCED OPERATION GUIDE
Original Orientation
To send the document in the orientation that can be read properly, specify
the upper orientation of original. To use the functions below, select the
orientation in which the original is set on the platen.
• 1-sided / 2-sided Selection
• Border Erase
* If [On] is selected as the Orientation Confirmation setting in the
System Menu, the selection screen for original orientation appears
when you select any of the above functions.
When placing the original on the platen
When placing the original on the optional document processor
Use the procedure below to select the orientation when placing the
originals on the platen for sending.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Type of Original/Transmission] and then [Original Orientation].
Original [Top Edge Top] [Top Edge Left]
Original [Top Edge Top] [Top Edge Left]