Sending Functions
2-6 ADVANCED OPERATION GUIDE
Zoom
Scans the original by automatically zooming it depending on the sending
size.
The table below lists the available options.
NOTE: When zooming in or out, see Sending Size Selection on page 2-4
when selecting the sending size.
When Custom Size or Size Entry is selected as the original size, the
originals are sent at normal size and zooming cannot be used.
Depending on the combination of original size and sending size, the image
is placed at the edge of the paper. To center the image vertically and
horizontally on the page, use the centering setting described in
“Centering”
on the page 2-7.
Use the procedure below to enlarge or reduce the original to match the
transmission size.
1
Place the originals on the platen.
2
Press the Send key.
3
Select the transmission size.
4
Press [Advanced Setup] and then [Zoom].
5
Press [100%] or
[Auto].
6
Press [OK].
7
Specify the destination, and press the Start key to start sending.
Item Detail
100% No Zoom (to be scanned at actual size)
Auto Zoomed automatically according to the specified
sending size.
Status 10/10/2007 10:10
Ready to send.
Destination
Add Shortc ut
Enlarge or reduce original when scanning .
[100%]: Scan at actual siz e.
[Auto]: Enlarge or reduce to match
sending size/storing size.
Cancel OK
Auto
Zoom
Place original.
100%
Press [OK] to display
1
the image.
To Next Page
Loading...
Need help?
General
