Sending Functions
2-24 ADVANCED OPERATION GUIDE
Background Density Adjustment
Lightens the background of the colored original when it is too dark.
NOTE: You cannot adjust the background density if you selected
[Monochrome] in Color Selection (see page 2-25).
Use the procedure below to set the background density when sending
scanned images.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Color/Image] and then [Background Density Adj.].
4
Press [On], and
press [1] to [5]
(Lighter- Darker) to
adjust the density.
5
Press [OK].
6
Specify the destination, and press the Start key to start sending.
Status 10/10/2007 10:10
Place original.
Cancel OKAdd Shortc ut
Ready to send.
On
Off
Bac kground
Bac kground Densit y A dj .
Lighter
12345
Darker
1
Press [OK] to display
Destination
the image.
To Next Page
Loading...
