Utax CD 1325

System Menu
ADVANCED OPERATION GUIDE 6-29
6
NOTE: Refer to page 1-25 and page 2-27 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Function Defaults, [T] and then
[Change] of Border Erase Default.
3
Press [+] or [–] for
the Border and
Gutter width to
erase.
You can use the
number keypad to
enter the number
directly.
4
Press [OK].
Margin Default
Set the default margin. The table below shows the measurement ranges
that can be set.
Use the procedure below to set the default margin width.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Function Defaults, [T] and then
[Change] of Margin Default.
Common Settings - Border Erase Def ault
Select the default border erase width.
Use [ -]/[+] or the numeric keys to enter a number.
Border(0 .00 - 2. 00)
0.23
Cancel OK
Status 10/10/2007 10:10
# Keys
Paper is remaining in Document Processor.
"
Gutter(0 .00 - 2. 00)
0. 47
# Keys
"
Input units Range
Inch models -0.75 to 0.75" (in 0.01" increments)
Metric models -18 mm to 18 mm (in 1 mm increments)