Copying Functions
1-6 ADVANCED OPERATION GUIDE
NOTE: You can conveniently select in advance the size and type of
paper that will be used often and set them as default (refer to Paper Size
and Media Type Setup for Multi Purpose Tray on page 6-9).
Use the procedure below to select the paper size and media type.
1
Place the originals on the platen.
2
Press the Copy key.
3
Press [Org./Paper/Finishing], [Paper Selection] and then [MP Tray
Reservation].
4
Press [Standard
Sizes 1 ], [Standard
Sizes 2 ], [Others] or
[Size Entry] to select
the paper size.
If you select [Size
Entry], press [+] or
[–] to specify X
(horizontal) and Y
(vertical) sizes. You
can enter the size
directly using the
numeric keys after
pressing [# Keys].
5
Press [Media Type].
6
Press [Media Type] to select paper type, and press [OK].
7
Press [OK].
8
Press [OK].
9
Press the Start key to start scanning the originals.
10
When the machine is ready, the confirmation screen for the specified paper
appears. Load the required paper in the Multi Purpose tray and press
[Continue] to start copying.
Status 10/10/2007 10:10
Ready to copy.
Copies
OK
Paper Selection - MP Tray Setting
Others
Size Entry
Plain
Media Type
Ledger
Legal
8.5x13 .5"
Letter
Statement
OficioII
Letter
Execut ive
1
Standard
Sizes 1
Standard
Sizes 2
Status 10/10/2007 10:10
Ready to copy.
Copies
OK
Paper Selection
Others
Size Entry
Plain
Media Type
X
(5 .83 - 17 .00 )
Y
"
# Keys
(3 .86 - 11 .69 )
"
# Keys
1
11.00
8.50
Standard
Sizes 1
Standard
Sizes 2
To Next Page
Loading...
Need help?
General
