Management
ADVANCED OPERATION GUIDE 7-3
7
4
Press [Next] of User Login Setting and then [Change] of User Login.
5
Select [Local
Authentic.] or
[Network
Authentic.]. Select
[Off] to disable user
login administration.
If you select
[Network
Authentic.], enter
the host name (62
characters or less)
and domain name
(254 characters or less) for the Authentication Server. Select [NTLM
(WinNT)] or [Kerberos (Win2000/2003)] as the authentication method.
NOTE: If the login user name and password are rejected, check the
following settings.
• Network Authentication setting of the machine
• User property of the Authentication Server
• Clock time setting of the machine and the Authentication Server
If you cannot login because of the setting of the machine, login with any
administrator registered in the local user list and correct the settings.
If the server type is [Kerberos (Win2000/2003)], only domain names
entered in uppercase will be recognized.
6
Press [OK].
Login/Logout
Once you enable user login administration, a user ID and password entry
screen appears each time you use this machine.
Log in using the procedure below.
Login
1
If the screen below
appears during the
operations, press
[Login User Name].
Us er Login/Job Accounting - User Login
Off
OK
Status
10/10/2007 10:10
Cancel
Host Name
Domain Name
NTLM
(WinNT )
Kerberos
(Win2000 /2003 )
Us er login adminis t rat i on.
Please select authentication method.
Local
Authentic.
Network
Authentic.
NTLM
(WinNT )
Login
User Name
Login
Status 10/10/2007 10:10
Enter login user name and password.
Login
Password
abcdef
********
To Next Page
Loading...
Need help?
General
