WRI400
The WRI400 is a networked access point controller that communicates with bright blue via RF through a mating
Panel Interface Module (PIM400-485-VBB). It is designed to provide wireless connectivity to electronic access
control components including credential readers, door position and request to exit switches.
Performance
▪ Verification Time - Less than 0.10 second (not including panel delays)
▪ Communications (Heartbeat) Interval - Configurable in 1 second increments from 1 second to 18 hours.
Heart Beat can be set to 1 second for override operation
▪ Features - Tamper Switch, Door Status Monitoring, Door Strike Relay, Aux Relay, and 2 Reader Head
operation.
▪ Inputs - Request-to-Enter, Request-to-Exit, Door Position Switch, Reader Tamper 1, Reader Tamper 2
▪ Addressing
Card formats
▪ Accepts card formats up to 255 bits.
Operational environment
▪ Temperature - -31ºF (-35ºC) to 151ºF (66ºC)
▪ Humidity - 0 - 100% condensing
Power source
▪ Power Requirements - 12 VDC or 24 VDC; 500 mA maximum current
Radio Frequency (RF) - The PIM includes an RF Transceiver.
▪ Optional Dynamic Channel Switching
▪ 900 MHz spread spectrum, direct sequence, 10 channels
▪ Frequency - 902-928 MHz
▪ Data Rate - RF: 40 kbps
▪ Modulo 256 error detection
▪ Encryption: AES-128 bit keys
▪ Approvals - FCC and RSS-210 (Canada)
▪ Transmitter Power - Up to 300mW
▪ Receiver Sensitivity - 90dBM typical
▪ Remote antenna modules - The PIM modules are capable of accommodating Remote Antenna Modules.
To Next Page
Loading...
