Warning: Serious damage may occur to the read-head if this jumper is set incorrectly. Please check the read-
head voltage requirements.
W2 - SBB-RI addressing. The address of the SBB-RI is dependent on the position of jumpers on these pins.
Please see the section on Addressing SBB-RI for more details.
Connecting to bright blue
Communication between the bright blue controller and a SBB-RI reader interface is via RS-485 protocol. Any
one of the Device connectors (Device 1-1 through 2-16) on the bright blue controller can be used to
communicate with P4 on a SBB-RI. The below example is using Device 1-1 on the bright blue controller and P4
on the SBB-RI.
Data Communication between bright blue and SBB-RI
To Next Page
Loading...
