▪ Direct sequencing spread spectrum
▪ Frequency: 902-928 MHz
▪ Data Rate: 62.5 kbps (half duplex)
▪ Modulo 256 error detection
▪ Selectable channels: 1 of 15 standard; 5 groups of 3 increased interference immunity (configurable)
▪ Approvals: FCC and RSS-210 (Canada)
▪ Transmitter Power: Up to 300mW
▪ Receiver Sensitivity: 90dBM typical
▪ Remote antenna modules - The PIM is capable of accommodating Remote Antenna Modules.
Range - 200 feet on one floor when used in normal office interior construction and up to 600 feet line of sight.
▪ Transmitter Power - Up to 200 mW
▪ Receiver Sensitivity - 90dBm typical
Wireless Reader Interface (WRI – Indoor or Outdoor)
The WRI-IN/OUT-12VDC acts as a remote card reading device that communicates via RF with bright blue
through a mating Panel Interface Module (PIM). The Schlage wireless modules are powered locally with 12 VDC
power supply. The modules will transfer a bit stream up to 255 bits from one card reader with any Wiegand, ABA
or custom formatted outputs. The WRI-IN/OUT-12VDC acts as a control interface for third party electric locking
mechanisms such as electric strikes and magnetic locks. The WRI-IN-12VDC communicates to its mating PIM up
to 200’ on the same floor in typical office construction and up to 1000’ line of site.
Performance
▪ Verification Time - Less than 0.10 second (not including panel delays)
▪ Communications (Heartbeat) Interval - Configurable in 1 second increments from 1 second to 18 hours.
Heart Beat can be set to 10 seconds for ARO and MRO operation
▪ Features - Tamper Switch, Door Status Monitoring, Door Strike Relay, Aux Relay, and 2 Reader Head
operation.
▪ Gate Control - WRI /OTD with Optional Long Range Antenna
▪ Addressing - Automatic during RF Linking
Card formats
▪ The WRI-IN/OUT-12VDC accepts card formats up to 255 bits.
Operational environment
▪ Temperature - -35°C to +66°C
▪ Humidity - 20% RH to 95% RH (non-condensing)
To Next Page
Loading...
