Example: http://10.45.49.65/index_ver.html
2 Click on the Version Display button. The full SRI Application Version Display window will open.
3 Check the Geomain_ nri field which displays what revision of firmware was loaded to the VBB-NRI during
the upgrade. If the data in this field corresponds to the version upgrade, your upgrade is successful.
Example: If you've just upgraded the VBB-NRI to VBB-NRI v10, it will read: SRI Board as VBB-NRI
with OEM Code: G4 V00:10 (created at: Jan 14, 2010 13:19:39) The "G4 V00:10" section states
that this is an VBB-NRI v10.
Additional Information
The following information will vary depending on the version of the firmware that has been uploaded to the SRI.
For our example with this upgrade, we are showing the following information:
â–ª Rootfs - Usually not updated during the upgrade
â–ª Uimage - Usually not updated during the upgrade
â–ª CredMgr - These values may change depending on if the firmware that has been loaded to the VBB-NRI
has been developed especially for a customer evaluation
â–ª Geomain - These values may change depending on if the firmware that has been loaded to the VBB-NRI
has been developed especially for a customer evaluation
▪ Geomain_ nri – Displays the current firmware version of the board.
To Next Page
Loading...
Need help?
General
