Vatech PAX-I - Page 127

PaX-i (PCH-2500) User Manual
127
Appendices
Guidance and manufacturer’s declaration - electromagnetic immunity
The model PaX-i(PCH-2500) is intended for use in the electromagnetic
environment specied below. The customer or the user of the model PaX-
i(PCH-2500) should assure that it is used in such an environment.
Emissions
test
Compliance
Compliance
level
Electromagnetic
environment -guidance
Electrostatic
discharge
(ESD)
IEC 61000-
4-2
±6 kV
Contact ±8
kV air
±6 kV
Contact ±8
kV air
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should be
at least 30 %.
Electrical
fast
transient/
burst
IEC 61000-
4-4
±2 kV for
power supply
lines ±1 kV
for input/
output lines
±2 kV for
power supply
lines ±1 kV
for input/
output lines
Mains power quality
should be that of a typical
commercial or hospital
environment.
Surge
IEC 61000-
4-5
±1 kV line(s)
to line(s) ±2
kV line(s) to
earth
±1 kV line(s)
to line(s) ±2
kV line(s) to
earth
Mains power quality
should be that of a typical
commercial or hospital
environment.
Voltage
dips, short
interruptions
and voltage
variations
on power
supply input
lines
IEC 61000-
4-11
< 5 % U
T
(> 95 % dip
in U
T
) for
0.5cycle 40
% U
T
(60 %
dip in U
T
)
for 5 cycle,
6 cycle 70
% U
T
(30 %
dip in U
T
) for
25 cycle, 30
cycle <5 %
U
T
(< 95 %
dip in U
T
) for
5 s
< 5 % U
T
(> 95 % dip
in U
T
) for
0.5cycle 40
% U
T
(60 %
dip in U
T
)
for 5 cycle,
6 cycle 70
% U
T
(30 %
dip in U
T
) for
25 cycle, 30
cycle <5 %
U
T
(< 95 %
dip in U
T
) for
5 s
Mains power quality
should be that of a
typical commercial or
hospital environment.
If the user of the model
PaX-i(PCH-2500) image
intensifier requires
continued operation during
power mains interruptions,
it is recommended that the
model PaX-i(PCH-2500)
be powered from an
uninterruptible power
supply.
Pi_u272_en_20180514.indd 127 2018-05-14 오전 11:03:33