Vatech PAX-I - Page 46

PaX-i (PCH-2500) User Manual
46
4. Software Overview
L. Exit
This button exits the capturing program.
M. Imaging Mode
This toggles the imaging mode – PANO or CEPH.
Refer to section
4.3.1 ~ 4.3.2
for the details regarding
PANO
and
CEPH
imaging modes.
N. Conrm
After conrming all settings required for scanning, press
Conrm
to apply the
settings.
NOTE
When you click ‘Confirm’, the scan time and estimated
DAP (Dose Area Product) value will be shown on the main
display for the exposure you are going to take.
O. Ready
This button is used when all aspects of preparation have done for image
acquisition (including parameter settings and patient positioning).
Pi_u272_en_20180514.indd 46 2018-05-14 오전 11:03:16