PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS DX-120 Programming Manual
- 164 -
Programming for Optional ISDN (T1/PRI)
You can make the settings needed for outgoing and incoming ISDN (T1/PRI) calls by using the following procedure.
HINT
Also refer to the Vertical DX-120 Installation and Maintenance Manual which can be
found on the Vertical CCC website (www.vertical.com/ccc).
There are other DX-120
user guides and manuals located on the CCC that are also useful in the installation,
programming, maintenance, and use of the DX-120 system.
PROGRAMMING FOR AN ISDN (T1/PRI) CARD VIA PC-DBA
ISDN (T1/PRI) technology is similar to the T1 (see page 155), by adding another option for digital trunking and allowing
you to increase the DX-120 trunk capacity (i.e., to 39 when including 16 analog CO lines). The ISDN (T1/PRI) also
adds Caller ID Flexibility (Inbound Number & Name, Outbound Number).
HINT
Also see...
• “Setting Up the Translation Table” on page 171
• “ISDN (T1/PRI) Call Operation” on page 321
• “Appendix F - T1 Maintenance” on page 480
• “Appendix D - Trunk Directory Numbers” on page 475
From the PC-DBA main screen:
1) Go to ProgrammingXC.O. Line ApplicationXISDN to display the C.O. Line Application -ISDN screen.
Programming for an ISDN (T1/PRI) Card via PC-DBA (continued on next page)
To Next Page
Loading...
