Vertical comdial DX-120 - Page 378

PROGRAMMING THIRD PARTY VOICE MAIL DX-120 Programming Manual
- 370 -
SET THE CALL HANDLING DIGITS VIA THE DET
NOTE
• chg, bksp, save, one, always, del, and ack are interactive LCD button operations.
Use the three buttons below the LCD display to activate the associated operation.
• You can press Hold at any time to return to the previous level or press the volume
buttons to return to the main DB selection screen.
1) Enter Database Administration (see page 26) using the feature code Feature # * to display the password
prompt.
2) Enter the DB Admin password (see page 27).
3) Press show to display the DB Item Select screen.
4) Press next to display each of the Call Handling Digits setting screens.
Setting Hunt Group for the VM table:
From the DB Item Select screen (see steps 1 through 3 above):
4) Enter 06-02-X-01 (where X is the Tenant Group: 1~3).
5) Press save to display the Voice Mail Table for Tenant 1 – Hunt Group.
6) Press chg.
7) Enter the UCD group (0~24) you want to use as the VM hunt group.
• The VM hunt group is the UCD group where you have programmed all of the VM type analog ports as
members.
8) Press save to store the setting.
9) Press next to continue programming the Prefix Table - ICM/VM (now to go step 6 in the next section).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Set the Call Handling Digits via the DET (continued on next page)