Vertical comdial DX-120 - Page 71

- 63 -
DX-120 Programming Manual BASIC SYSTEM PROGRAMMING TASKS
Setting Up Pre-Programmed Messages via the DET (continued)
Setting Up Premise Messages
From the DB Item Select screen (using steps 1 to 3 on page 62):
4) Enter 04-07-02-01.
5) Press save to display Preprogrammed Messages – Premise (Text)
Message – 1.
6) Press next (if necessary) to advance to the next preprogrammed message.
7) Press chg to enter a new message for the selected preprogrammed message.
8) Use the chart and the dial pad keys to enter the new message. When finished:
9) Press save to store the settings.
Repeat steps above for additional messages.
10)Press the Hold button to return to the previous menu level.
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).