Vertiv Liebert APM2 - Option Configurations; Options List; Options Introduction

To Next Page

To Previous Page

9 Vertiv™ Liebert® APM2 Option Configurations

This chapter provides the information about available options for Liebert® APM2 UPS.

9.1 Options List

No. Option Name Remark

1 Battery temperature sensor kit -

2 Battery ground fault kit -

3 Seismic anchor kit -

4 IS-UNITY-DP card Intellislot ports 1 to 2

5 IS-UNITY-LIFE card Intellislot ports 1 to 2

6 SIC card Intellislot ports 1 to 2

7 UF-RS-485 card Intellislot port 1

8 IS-RELAY card Intellislot ports 1 to 2

9 External remote LBS box

10 BCB cabinet

11 Parallel cable Available in 5 m, 10 m, 15 m

12 LBS cable Available in 10 m, 15 m, 20 m

13 Common source copper bar -

Table 9.1 Options List

NOTE: The RS-232 of Intellislot 2 shares communication resources with the RS-485 of the HMI RJ-45 interface. To

avoid conflicts, when using the HMI interface to communicate with BMS, the Intellislot interface 2 can only connect to

the IS-Relay card.

9.2 Options Introduction

9.2.1 Battery temperature sensor kit

The battery temperature sensor is used to detect the battery temperature. This kit allows for adjustment of the float charging

voltage of the battery that makes it inversely proportional to the ambient temperature of the battery. This helps to prevent

over charging of the battery during high ambient temperature.

NOTE: Keep one battery temperature sensor and one cross head screwdriver handy before starting the installation.

CAUTION: Install the battery temperature sensor kit following the given steps, to avoid, damages to the UPS

and the battery.

9 Vertiv™ Liebert® APM2 Option

Configurations

Vertiv™ Liebert® APM2 30 to 120 kVA Modular UPS User Manual

Other manuals for Vertiv Liebert APM2