Vertiv™ NetSure™ Control Unit (NCU) User Manual
NMSV3 Configuration Description (Network Management System)
Configures SNMP Version 3 parameters.
You can configure the following parameters.
• Use Name: The permitted User to access the NMSV3 agent.
• Priv Password DES: The privacy DES password used to encrypt the data.
• Auth Password MD5: The authorization MD5 password used to encrypt the digital signature.
• Trap Enabled: Trap function enabled or disabled.
• Trap IP: The IP to which the trap is sent. Check the IPV6 box when entering an IPV6 trap address.
• Trap Security Level: The SNMP v3 data security level (NoAuthNoPriv, AuthNoPriv, or AuthPriv).
- NoAuthNoPriv: SNMP messages are sent without authentication and without privacy.
- AuthNoPriv: SNMP messages are sent with authentication but without privacy.
- AuthPriv: SNMP messages are sent with authentication and with privacy.
NOTE!
For SNMP v3, the security level for Get and Set operations is set to “AuthPriv” and cannot be adjusted.
NOTE!
Controller must be reset after configuration of initial SNMP v3 User (Advanced Settings Menu / SW Maintenance Tab
/ Restore Factory Defaults / Reboot Controller).
Figure 5.58 SNMP - NMSV3 Configuration
box when
entering an IPV6
trap address.
To Next Page
