Vertiv™ NetSure™ Control Unit (NCU) User Manual
Web Menu Navigation:
Settings Menu / Time Settings Tab.
In the Specify Time section, click on "Get Local Time from Connected PC" and then “Set” to automatically set the date and time. To
manually set the date and time, click on “the clock symbol” and enter the date and time. See Figure 2.3. Then select the “Confirm”
button. Then click on “Set” to save the change.
Figure 2.3 Manual Date and Time Menu
2.9.13 Adding, Deleting, and Modifying Users
Local Menu Navigation:
None.
Web Menu Navigation:
Advance Settings Menu / Users Tab.
2.9.14 Setting IP Communications Parameters (if controller not set as DHCP or DHCPv6)
See also “Setting IPv4 Communications Parameters (if controller not set as DHCP)” on page 20 and “Setting IPv6 Communications
Parameters (if controller not set as DHCPv6)” on page 21.
Local Menu Navigation:
Main Menu / Settings Icon / Comm Settings / enter parameters.
Web Menu Navigation:
Advance Settings Menu / Ethernet Tab / enter parameters.
2.9.15 Setting for DHCP and DHCPv6
The DHCP and DHCPv6 functions allow the controller to acquire an IP address automatically. This function can only be enabled or
disabled via the local display and keypad. If this function is enabled and the acquisition of an IP address fails, an alarm is generated. If
the acquisition of an IP address is successful, you need to record the IP address automatically acquired by the controller to access the
controller via the Web Interface. This IP address is displayed on the main system info screen (Main Menu / ESC) in the IP Address
field or in the local display menu (Main Menu / Settings Icon / Comm Settings) in the IP Address field below the DHCP setting.
To Next Page
Loading...
Need help?
General
