Vertiv⢠NetSure⢠Control Unit (NCU) User Manual
2.8 Logging into the Controller via Web Interface Access
Procedure
Internet Explorer, version 6 or newer, is supported (IE 8.0 is recommended). Chrome, Safari, and Firefox are also supported.
1. In your browser, enter http:// and the controllerās IP address (see āConnecting a Local Computer Directly to the Controller
when the System is NOT Equipped with an IB4 Boardā on page 22 or āConnecting a Local Computer Directly to the Controller
when the System IS Equipped with an IB4 Boardā on page 24) and press ENTER. If your site requires secure HTTP and you
were furnished with an NCU configuration with secure HTTP, enter https:// and the controllerās IP address and press ENTER.
2. If this is the first time the NCU is accessed remotely, the following screen appears. This informs a User to change the default
password the first time the NCU is accessed remotely. If the below procedure was performed, for subsequent logins the
window in the next step appears.
a) Enter the old password (default 640275).
b) Enter a new password.
c) Re-enter the new password.
d) Click the āConfirm Buttonā.
NOTE!
By default, the āUser Nameā is "admin" and the āPasswordā is ā640275ā. See also āUsers Tabā on page 172.
3. The following Web Interface Login window opens. Enter a valid User Name and Password, then click LOGIN.
NOTE!
Before entering a User Name and password, you can select a local language that the Web Interface menus use from
those listed in the top right corner of the login window. See āLanguage Tabā on page 185.