Vertiv™ NetSure™ Control Unit (NCU) User Manual
6.3 MIB Installation
6.3.1 Installation
The Controller’s MIB is named "Netsure-NCU.mib". Contact your Vertiv representative for the location on the Web to download the
MIB file.
Use the MIB loading function of the NMS to load the MIB database. Refer to the User Manual provided with the NMS for the detailed
loading method.
6.3.2 Contents of the Controller’s MIB
The contents of the MIB supported by the controller's SNMP agent and the OID are listed in Table 6.1. For the details, refer to the MIB
file named "Netsure-NCU.mib".
6.4 Accessing the Controller through an NMS
6.4.1 Apply Administrative Privilege
In order to use the NMS to manage the devices connected to the controller, the administrative authority needs to be applied for the
NMS, that is, add the NMS information to the access list of SNMP agent.
Add NMS through Web Browser
Refer to “NMSV2 Configuration Description (Network Management System)” on page 182 and “NMSV3 Configuration Description
(Network Management System)” on page 184 for the method of adding NMS.
6.5 ESR Configure
The EEM Protocol is used for communication between the Main Computer and the controller. The Main Computer is the computer
superior to the NCU (the client of the NCU). On this page, all parameters needed for communication with a main EEM computer are
to be set.
User Information Configuration: On this page, Users, their privilege and password are configured.
Time Synchronization: On this page, the system time and date are to be set.
Automatic time synchronization from time servers can also be configured.
To Next Page
Loading...
Need help?
General
