Vertiv™ NetSure™ Control Unit (NCU) User Manual
3. Change the following parameters as desired and click on “Set”.
• Signal Full Name: Name displayed in the Web Interface menus.
• Signal Abbr Name: Name displayed in the local display menus.
• Low 1 Alarm Limit: Sets the Low 1 alarm point.
• Low 1 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• Low 1 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• Low 2 Alarm Limit: Sets the Low 2 alarm point.
• Low 2 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• Low 2 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• High 1 Alarm Limit: Sets the High 1 alarm point.
• High 1 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• High 1 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• High 2 Alarm Limit: Sets the High 2 alarm point.
• High 2 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• High 2 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
To Next Page
