Vertiv™ NetSure™ Control Unit (NCU) User Manual
3. Change the following parameters as desired and click on “Set”.
• Signal Full Name: Name displayed in the Web Interface menus.
• Signal Abbr Name: Name displayed in the local display menus.
• Signal Units: The units being measured.
• X1: The lowest transducer value to be measured. Example 0 mV, 0 mA.
• Y1(value at X1): Lowest “Signal Units” value to be displayed when transducer measurement is at the lowest value (X1).
Example when the transducer measured value is 0 mv the displayed units is 0 gallons.
• X2: The highest transducer value to be measured. Example 25 mV, 25 mA.
• Y2(value at X2): Highest “Signal Units” value to be displayed when transducer measurement is at the highest value
(X2). Example when the transducer measured value is 25 mv the displayed units is 1000 gallons.
• Low 1 Alarm Limit: Sets the Low 1 alarm point.
• Low 1 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• Low 1 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• Low 2 Alarm Limit: Sets the Low 2 alarm point.
• Low 2 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• Low 2 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• High 1 Alarm Limit: Sets the High 1 alarm point.
• High 1 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• High 1 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
• High 2 Alarm Limit: Sets the High 2 alarm point.
• High 2 Alarm Severity: Alarm level for this alarm. (See also Table 1.1 on page 3.)
• High 2 Alarm Relay: Select a relay number to map to this alarm.
“None” means there is no related relay number.
To Next Page
