Vertiv NetSure M830B User Manual

Vertiv™ NetSure™ Control Unit (NCU) User Manual
219
EEM Protocol
You can set EEM protocol parameters.
Figure 5.91 EEM Protocol
• Protocol Type: Select EEM, RSOC, or SOC/TPE per site requirements.
• Protocol Media: Select RS-232, Modem, IPV4, or IPV6 per site requirements.
• Port Parameter: Enter the port parameters per site requirements.
• Callback Enabled: Select per site requirements.
• Report Enabled: Select per site requirements.
• CCID: Enter value per site requirements.
• Maximum Alarm Report Attempts: Enter value per site requirements.
• Call Elapse Time: Enter value per site requirements.
• Safety Level: Select per site requirements.

Vertiv NetSure M830B Specifications

General

Brand	Vertiv
Model	NetSure M830B
Category	Controller
Language	English