Chapter 4 Deployment of the CPU 21x-2BT10 with TCP/IP Manual VIPA CPU 21x
4-22 HB103E - Rev. 05/45
Save and compile your project and close NetPro.
To store the CP project engineering data in the system data, you have to
activate the option "Save configuration data on the CPU" (default setting)
at object properties area Options in the hardware configuration of the CP.
For the execution of connection commands at the PLC, your CPU requires
an user application. For this, exclusively the VIPA handling blocks
AG_SEND (FC5) and AG_RECV (FC6) are used. The blocks are part of
the VIPA library that is included in the consignment as CD (SW830).
Specify the according CP via the parameters ID and LADDR by calling FC5
res. FC6.
There are 3 possibilities to transfer your project into the CPU:
• Transfer via MPI
• Transfer via MMC using a card reader
• Transfer via CP (Minimal project necessary)
More detailed information about this is to be found below at "Transfer
project".
The following pages provide a more detailed description of the steps of the
fast introduction.
Save and compile
connections
PLC user
application
Transfer project
To Next Page
Loading...
Need help?
General
