VIPA CPU 21 Series - Page 393

Manual VIPA CPU 21x Index
HB103E - Rev. 05/45 A-3
Event-ID ............................. 12-35
Example
CPU 21x-2BT02 .....................5-24
CPU 21x-2BT10 .....................4-45
CPU 21xDP ............................7-28
CPU 21xSER-1 Modbus.......... 9-24
F
Factory setting......................3-16
Features...............................1-14
Firmwareupdate ...................3-17
function selector ................... 2-13
G
Green Cable hints ..................1-4
GSD ................................6-4, 7-6
including....................................7-8
H
H1 ..........................................5-4
Hardware description.............. 2-1
Host-ID................................. 4-11
Hub..................................4-6, 5-2
I
IND.....................................11-30
Industrial Ethernet ..................5-4
Instruction list ....................... 12-1
Integrated blocks.................. 11-1
OBs.........................................11-3
SFBs.......................................11-3
SFBs (Standard).....................11-4
SFCs (VIPA specific)..............11-6
IP address..............................5-9
ISO/OSI reference model.......4-3
L
Library include......................11-7
M
min_slave_interval..................7-5
MMC...................3-13, 4-38, 6-11
Modbus
Function codes .......................9-20
Principles ..................................9-6
MPI..............................3-11, 4-37
Configuration .................3-12, 5-19
Hints..........................................1-3
Interface..................................2-14
Transfer via.............................3-11
Multicast......................4-16, 4-31
N
NCM diagnostic....................4-39
NetPro.................................. 4-27
Addresses...............................4-30
Connections............................4-29
Fast introduction .....................4-21
ID............................................ 4-29
LADDR ................................... 4-29
Route...................................... 4-29
Station .................................... 4-28
link up ................................ 4-28
Network ...........................4-6, 5-2
Variants .................................. 4-14
Network layer..........................4-4
O
operating modes...................2-13
Optical waveguide ...........6-4, 7-6
ORG format.................4-42, 5-38
OVERALL RESET..................3-3
Overview System 200V...........1-5
P
PAFE..................................11-31
Parity ...........................9-12, 11-9
Passive operation.................10-6
PDO......................................8-17
Peripheral module
Addressing ............................... 3-4
PLC header .................4-44, 5-39
Port.......................................4-30
Presentation layer...................4-5
Principles................................1-1
Procedures.............................9-4
Profibus-DP............................6-2
Addressing ........................6-4, 7-6
Communication protocol .......... 6-3
communication protocols ......... 7-3
Connectors............................. 7-23
Data consistency...............6-3, 7-5
Data transfer............................. 7-4
Master ...............................6-2, 7-2
Slave..................................6-2, 7-2
Data communication.....6-3, 7-3
Termination ............................ 7-22
Token-passing-procedure ........ 6-3
Project transfer
CAN........................................ 8-10
CP .......................................... 5-19
CPU........................................ 3-11
DPM ......................................... 6-9
Protocols ................................9-3
PtP communication
Broadcast ................................. 9-5
Q
QANF/ZANF .......................11-31
R
Registers ..............................12-7
RFC1006................................4-9
Route....................................4-29