What to do if the burner goes to lockout after the prepurge period because the flame does not ignite on my Wacker Neuson Heater?
If the burner locks out after the prepurge period because the flame doesn't ignite, consider these causes: * Air in the gas line: Bleed the gas line. * Gas valve passing too little gas: Check and adjust the gas pressure. * Irregular or absent spark: Readjust the ignition electrode.
What to do if the burner continues to repeat the starting cycle without going into lockout on my Wacker Neuson E3000?
If the burner continues to repeat the starting cycle without locking out, reset the gas pressure switch, as it may be set incorrectly.
What to do if the burner does not go through prepurge, and the control module goes to lockout on my Wacker Neuson E3000?
If the burner doesn't go through prepurge and the control module locks out, adjust the combustion head. This issue arises when the air pressure switch isn't changing from normally closed to normally open because there's not enough air pressure in the combustion head.
Provides essential safety rules for operating the equipment safely.
Covers safety procedures and precautions for maintenance and repair activities.
Lists checks and preparations required before transporting the machine.
A list of essential checks to perform before starting the machine.
Instructions for preheating the Heat Transfer Fluid to prevent pump damage.
Procedure for resetting the machine after a low Heat Transfer Fluid fault.
Procedure for adjusting and verifying the position of the burner electrodes.
Common problems, their reasons, and remedies for the main machine.
Addresses issues related to the oil burner's operation and potential faults.
General| Electrical Requirements | 230 V, 50 Hz |
|---|---|
| Voltage | 230 V |
| Operating Voltage | 230 V |
| Heat Capacity | 3000 W |
| Fuel Consumption | 0.3 l/h |
| Tank Capacity | 12 l |
| Fuel Tank Capacity | 12 l |
| Heating Capacity | 3000 W |
| Fuel Consumption (l/h) | 0.3 l/h |
| Tank Capacity (l) | 12 l |
| Power Consumption | 3 kW |
To Next Page
