Wayne 4310 - Page 68

REMOTE CONTROL (GPIB & RS-232) 5–16
MEASUREMENT MODE
:MEAS:EQU-CCT <disc>
Select the equivalent circuit type for AC
tests.
Parameters:
The following parameters are valid:
SER Series equivalent circuit.
PAR Parallel equivalent circuit.
Example: :MEAS:EQU-CCT SER
will select the series equivalent circuit.
Response:
None.
:MEAS:EQU-CCT?
Returns the currently selected equivalent
circuit.
Parameters:
None.
Response:
Returns the equivalent circuit flag
according to this table:
0 Parallel.
1 Series.
Example: 0
indicates the parallel equivalent circuit
is selected.
:MEAS:FUNC1
Select first measurement function (Func 1).
:MEAS:FUNC1 C Capacitance
:MEAS:FUNC1 L Inductance
:MEAS:FUNC1 X Reactance
:MEAS:FUNC1 B Susceptance
:MEAS:FUNC1 Z Impedance
:MEAS:FUNC1 Y Admittance
:MEAS:FUNC1 Q Quality factor
:MEAS:FUNC1 D Dissipation factor
:MEAS:FUNC1 R Resistance
:MEAS:FUNC1 G Conductance
:MEAS:FUNC1 A Phase Angle
:MEAS:FUNC1 RDC DC Resistance
Example: :MEAS:FUNC1 C
will select Capacitance.
Response:
None.