Weinig Profimat 23 E - Accident Prevention during Setup

Tech. Dok. / L23 880 02 / 01.00.02 © MICHAEL WEINIG AG
Basic setting
4-3Profimat 23 E
Accident prevention
Select manual mode for basic settings.
Before switching on a spindle, check that it
rotates smoothly by hand and verify the entire
setting.
Replace extractor hoods and safety
mechanisms immediately after making an
adjustment.
Never advance feed or feed/top spindle onto a
measuring device or piece of timber. In other
words, always make adjustment, then position
measuring equipment, repeat adjustment, etc.
Use jog switch for motor-driven adjustment.
All machine clamps which are released in
order to make an adjustment must always be
retightened immediately after the adjustment.