Weinig Profimat 23 E - Page 71

Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Troubleshooting
7-5Profimat 23 E
a) Readjust tool relative to fence
b) Readjust rebate cutter relative to rebate
fence
a) Readjust feed rollers to middle of
workpiece
b) Resharpen straightening tool
a) Realign knives in tool body
b) Resharpen straightening tool
a) Realign tool relative to table
a) Readjust tool relative to fence
a) Edge-jointing tool not set correctly
relative to fence
b) Rebate cutter on straightening
spindle not set correctly relative
to rebate
fence
a) One feed roller exerts one-sided pressure,
or two rollers exert one-sided pressure
due to height difference in unmachined
workpiece
b) One-sided wear of straightening tool due
to constantly same timber width
a) Tool cutting edges not parallel to
table or fence
b) One-sided wear of tools
a) Lower tool a tiny bit too low
a) Workpiece drifts away from fence
because tool set behind fence
Remedy
No.
Possible cause
Fault
8
9
10
11
12
Point/hollow joint
when edge-jointing
Workpiece spirally
distorted
Workpiece not parallel
laterally
Workpiece not parallel
over full length –
height
Workpiece not parallel
over full length –
width
;;
;;
;;
;
;;;
;;;
;;
;
;
;;
;;;
;;
;
;;
;;
;;
;;;
;;;
;;
;
;;
;;;
;;;
;
;;;
;;;
;;
;;
;;;
;;
;;
;;;
;;;
;;;
;
;;
;;;
;;;
;
;
;;;
;;;
;;
;
;;;
;;;
;;
;
;;
;;
;
;;
;;
;;
;
;;
;;;
;;;
;;
;;;
;;;
;