Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Data, transport, start-up
8-5Profimat 23 E
Emission levels
Noise
Noise emission levels measured in the workplace (DIN 45 635, Part 1656)
Idle / Machining........................................................................................... < 85.0 dB(A)
The emission values referred to the workplace were measured in accordance with the
machining and measuring conditions stipulated by DIN 45 635, Part 1656
(woodworking machines, particular specifications for two-sided and multi-sided milling
machines).
Standard conditions for moulders (the first bottom, right-hand, left-hand and top
spindles in use in each case):
Workpiece: Preplaned soft wood 100 x 80 mm
Machining: 3 mm on all sides with chip extraction
Tools: 4-edged, parallel to axis, horizontal dia. 125 x 130 mm
vertical dia. 125 x 100 mm
Cutter projection 1.5 mm
For spindle dia. > 40 mm: tool dia. 140 mm
Speed: n = 6000 rpm (or nearest possible)
Feed rate: 15 m/min.
Distance of table plates: 4 mm from tool
Nationally applicable noise ceilings may be exceeded on account of special
circumstances (e.g. room, workpieces, tools, feed rate, etc.). The owner is responsible
for introducing additional soundproofing measures.
Dust
The machine has been tested with regard to dust emissions. The test report is available
from WEINIG on request.
To Next Page
Loading...