PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
Alternative installation in case of
sideways restriction due to a wall
Note:
In case of sideways restriction due to a
wall, the "cover caps for transoms" must be
attached to the transoms prior to the
installation of the fabric package.
• Hexagon cap nut (1) pushed through
the lower bore of the transom and the
"cover cap for transom" (4) attached
from the side.
Installation of the fabric package with
LED transoms
1. Unscrew the hexagon cap nuts on
the corresponding carriage and
remove the 13 x 1.5 x 58 sleeve.
2. Plug in the LED transom
3. Plug the 13 x 1.5 x 58 sleeve
through the LED transom's bottom
hole onto the carriage's axis (1).
4. Remount the hexagon cap nut like
the previous staves (2).
5. Then the cover cap can be mounted
(3).
With the LED transom make sure that the
leads inside the transom are drilled to a
soft eye on the end cap. Furthermore,
make sure that the rubber grommet above
the transom (lead entry into transom) is
turned outwards. If this is not the case
water may accumulate inside the transom.
To Next Page
Loading...
Need help?
General
