Input, Output and LED Settings
Signals of the Binary Output Relays on OR- 4 X
Signal Description
BO 1 Signal: Binary Output Relay
BO 2 Signal: Binary Output Relay
BO 3 Signal: Binary Output Relay
BO 4 Signal: Binary Output Relay
DISARMED! Signal: CAUTION! RELAYS DISARMED in order to safely perform
maintenance while eliminating the risk of taking an entire process off-line.
(Note: The Self Supervision Contact cannot be disarmed). YOU MUST
ENSURE that the relays are ARMED AGAIN after maintenance
Outs forced Signal: The State of at least one Relay Output has been set by force. That
means that the state of at least one Relay is forced and hence does not
show the state of the assigned signals.
181 MCDGV4 DOK-HB-MCDGV4-2E
To Next Page
