Xerox 4595 - Page 303

Xerox 4595 Copier/Printer System Administration Guide
8-145
8. Setups
KEY POINT: The following numbers cannot be
used: 224.XXX.XXX.XXX to 255.XXX.XXX.XXX and
127.XXX.XXX.XXX.
• Primary Server Name: Select the server name for the
primary server. A maximum of 64 characters may be
used.
NOTE:Use this feature when the Primary Server Setup
setting is By Server Name.
4. Select Save; you are returned to the Primary Server screen.
5. Repeat Steps 1-4 for the remaining items.
6. From the Primary Server screen, select Close to return to the
Address Search (Directory Service) screen.
Primary Server Port
Number:
Select the directory server port number in the range of 1-65535.
Secondary Server Select the default directory server settings (secondary server)
using the following procedure.
1. From the Address Search (Directory Service) screen, select
Secondary Server.
2. Select the item to be set, and select Change Settings.
3. Select the desired value for that item.
• Secondary Server Setup: Select the secondary server
specification method either By IP Address or By Server
Name.
• Secondary Server IP Address: Select the secondary
server IP address using values between 0-255.
NOTE:Use this feature when the Secondary Server
Setup setting is By IP Address.
KEY POINT: The following numbers cannot be
used: 224.XXX.XXX.XXX to 255.XXX.XXX.XXX and
127.XXX.XXX.XXX.