TCP/IP (LPD or Port9100)
255
Computer Setup
Install the print driver on the client computer. Refer to the HTML document on the PCL
Print Driver CD-ROM.
Test Print
Make sure the machine has been installed on the network correctly by submitting a test
print from each client computer. Perform the following steps.
1.
Open a document on a client computer.
2.
Select the machine as the printer.
3.
Print the document on the machine and verify that it prints correctly.
4.
Make sure that the print driver is installed on every computer that will be sending
jobs to the machine.
5.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to
Problem Solving on page 341
.
TCP/IP (LPD or Port9100)
This section explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided:
Information Checklist – page 255
TCP/IP (LPD or Port9100) Environments – page 256
TCP/IP (LPD or Port9100) Installation – page 256
Installation Procedure – page 256
Network Communication Setup – page 257
Computer Setup – page 257
Test Print – page 257
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
Item By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
• Host name
Customer
Test the machine to make sure that it is fully installed and functioning
correctly.
Customer
Install the print driver. Customer
To Next Page
Loading...
Need help?
General
