6Setups
74
• Print when delivery fails
Prints a “Transmission Report - Job Undelivered” for a transmission failure.
File Transfer Report - Fax Server
Allows you to set whether to print a transmission report after the machine sends
scanned data using the Server Fax service.
•No Print
Does not print a report regardless of whether data transmission is successfully
completed or not.
• Print Report
Automatically prints a transmission report for a successful transmission, and a
“Transmission Report - Job Undelivered” for a transmission failure.
• Print when delivery fails
Prints a “Transmission Report - Job Undelivered” for a transmission failure.
NOTE: When [IPv4 - IP Address] is not set under [Protocol Settings] in [Connectivity &
Network Setup], no destination will be written in reports.
2 Sided Report
Specifies whether a report is to be automatically output to both sides of paper or one
side only.
Recipient on Activity Report
Specifies the section of the destination’s information to be printed on an Activity Report.
Select [First 40 characters] or [Last 40 characters].
Job Flow Error Report
Specifies whether to automatically print a Job Flow Error Report.
Maintenance
This feature allows you to initialize the hard disk on the machine, to delete all document
data stored in the machine, and to enter software options.
1.
Select [Maintenance] in the
[Features] menu.
2.
Change the required settings.
3.
Select [Close].
Initialize Hard Disk
This feature allows you to initialize the hard disk on the machine. After selecting
[Initialize Hard Disk], select a partition, and then select [Start]. Then select [Yes] to
execute initialization. After the initialization is completed, select [Confirm].
NOTE: This process may take a while depending on the machine configuration.
To Next Page
Loading...
Need help?
General
