Xerox 5222 - Storing and Handling Paper; Supported Paper Sizes and Types; Supported Paper Sizes

Storing and Handling Paper
23
Storing and Handling Paper
Always use high quality, xerographic grade paper in the machine. Damaged, curled, or
damp paper can cause jams and image quality problems. Follow these simple rules to
store paper.
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Do not store paper in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported by each paper tray, output tray, and
the duplex module.
NOTE: For the capacity of each tray, refer to
Appendix on page 421.
Standard Sizes
NOTE: The standard sizes of paper that can be detected vary depending on the paper
size table specified by the System Administrator. For information on setting the paper
size table, refer to
Paper Size Settings in the Setups chapter on page 78.
Paper Trays - Standard Sizes
Paper Size
Dimensions
(mm)
LEF/
SEF
Tray 1, 2
/
Tray 3, 4
(Two Tray
Module)
Tray 3, 4
(High
Capacity
Tandem
Tray)
Tray 5
(Bypass
Tray)
Tray 6
(High
Capacity
Feeder)
Envelope
Tray
A6 105.0 148.0 LEF O
A5 148.0 210.0 SEF O
LEF O
A4 210.0 297.0 SEF O O
LEFOOOO
A3 297.0 420.0 SEF O O
B6 128.5 182.0 SEF O
B5 182.0 257.0 SEF O O
LEF O
B4 257.0 364.0 SEF O O
5.5 × 8.5” 139.7 215.9 SEF O O
LEF O